About us  /  Organization  /  Quality Assurance  /  CSR  /  Contact  /  News

News

Complex high current PCB design ideas - Hemeixinpcb

Release time: 29/04/2018

Designing and manufacturing PCBs are a procedure that requires some serious energy and is not considered a simple thing. Despite the fact that there are lovers who are ready to make their own planks at home with the right materials, however, they usually tend not to be as stunning as the machine ones. Also, it would be pretty tedious to make a lot of PCBs. Below, are high current PCB design tips you need to know. 

Since we operate a high-voltage circuit board, there are some things that we need to consider. Protection turns energy into heat. Given that this heat can be excluded from the track at the same speed as it was created, the trace remains at the same heat. Since the heat difference controls the thermal transition, the higher the heat difference, the more heat that flows between the hot and icy. 

Complex high current PCB design ideas

One good test is to get a spare board having different widths and a length of the route on it and to connect the trace to the power limited source. Then you can activate the power in stages and abandon it so that the time parameters are balanced at each power level. In a typical environment, say that 25degC with PCB in the air, which goes as a conductor, you may be surprised exactly how much power can pass a small path before it fails. 

The frustration mechanism is usually the heating of traces outside the de-lamination heat of PCB FR4 material, which is bent, and then the traces become undisclosed and rise from FR4, which implies that it loses most of its conductive and suddenly that the local area of it the trace quickly spreads in heat, and the copper actually dissolves, revealing a trace.

To avoid that you take a short section, say an 8-mile track, and use it to combine two large copper areas together, then it can transfer more power than a long section of the track. From memory it was a run of 3, Say, for example, the track has a width of 10 m, and then in the event that you use 3 times this length (30 miles) and agree with it to fill the pillows 3 times wider, for example. 30 mil, that is at least 3 x traces, then you will double the limit of the trace power. Thus, you can make a serpentine shunt and place drop at every step. These shunts are used to protect the MOSFET from the breaker on the drive drivers, it can be 4A with an explicit 12V load, but they must be able to drive through 8A-overvoltages and go into a mode of protection above 10A or short output.

Want to know more information about IC Substrate log in to - www.hemeixinpcb.com or call us at +86 0755-27586529 you can mail us at sales@hemeixinpcb.com